How to Replace a Nissan Juke Spare Key

Nissan Juke is an attractive and enjoyable hatchback with distinctive engine configuration. It's noisy, but it's enjoyable to drive.

The battery that powers the key fob on your nissan juke needs to be replaced every two years or at the latest, or if it's low. It is easy to do at home, but you'll require some tools.

Dead Coin Battery

If your Nissan Juke key fob isn't working the first thing you need to be sure of is the battery within it. It could be dead and needs to be replaced. This is a straightforward fix that takes only a few minutes. Flip the fob upside down so that you will be able to access the tiny latch/release located at the back. Remove the battery that was in use and then put in the new one, making sure it's facing downwards in the fob and line between the two halves of the fob in a careful manner.

If the fob was exposed to water, it will need to be cleaned prior to putting the new battery into. You can clean the fob by using isopropyl electronic cleaner and paper towel. Then allow it to dry completely prior to reinstalling the battery.

The key fob must also to be connected to the car in order to be able to start the car. This is done by following the directions in the owner's manual or using an OBDII scanner. The most likely reason the key fob was not working is because it wasn't paired. It is also possible that the fob has malfunctioning chips, but this is extremely rare. In this instance, a new receiver module could be needed. If this is the case it must be replaced by an expert technician.

Water Damage

The key fobs are battery-operated and the batteries should be replaced every two years or when the car stops responding when press the "start" switch. Keys are fitted with rubber seals to keep water out, but submerging the key fob in a pool or ocean water can cause damage to the electronic chip inside. If this is the case you'll need a replacement key from Nissan or locksmith.

It's possible that the computer has lost connection with the key fob that could result from a variety of factors. A simple restart of the car could fix the issue, however if the key's still displaying the "Key ID" error message, you'll have to contact Nissan or an auto locksmith to get help.

Three of the most common causes are a dead battery on the key fob as well as a key not programmed, and a damaged key fob. The first two issues are easy to fix, and the third is more difficult to identify and repair on the spot, but it can be fixed with a bit of patience. Compare nissan lost key Key Replacement Car Key Nissan Qashqai prices near you with WhoCanFixMyCar and schedule your repair online. Read reviews about local Nissan dealerships, Nissan mechanics, and garages in a matter of minutes.

Faulty Chip

The key fob of your Nissan Juke has a special chip that sends a signal to the car when you turn it. The key can stop working when the chip is defective. In this case, you can only fix the problem by replacing the key. There are a myriad of reasons your nissan new key Juke's key may be defective, such as water damage or a dead battery for your coin or a malfunctioning receiver module.

If your key fob stopped working after washing it or bath, you must check the chip for water damage. Check that the metal retainers on the chip are tight. Also, ensure that the chip isn't exposed water. If you observe any signs of water damage to the electronic component, remove the battery and wipe it down with isopropyl alcohol or electronic cleaner.

If the chip is defective, you will need to visit your local locksmith shop or dealership. They will need to know the year as well as the model, make and year of your vehicle to find an alternative. It is also necessary to write down the VIN (Vehicle Identification Number) so that the locksmith or dealer knows precisely which key you own. This will enable them to check the correct key code, and ensure that they cut the correct one.

Faulty Receiver Module

The key fob transmits a radio frequency signal to your car that performs a number of functions. It can unlock the trunk while you rush to get groceries or start your car by pressing the button on the fob. It can even open your windows and switch on the horn in case you accidentally lock your keys inside the car.

If the key fob stops functioning, it could be a problem with the receiver module inside the vehicle. The receiver modules are tuned to detect specific frequencies that match the signals that are transmitted by the Nissan key fob. If your car is equipped with a faulty receiver module and it stops responding to any signal from the key fob.

Regardless of how your Nissan key fob is damaged, it is always recommended to have a spare in case the key gets damaged or lost. A spare key can be programmed by a locksmith or dealership to work with your nissan qashqai keys locked in car and will save you the hassle of locking your keys in your car or losing them.

If your Nissan Juke's key fob was exposed to rain or clean tap water, you can solve the problem by cleaning it using isopropyl, or an electronic cleaner. If the chip has become damaged, you will need to purchase the new keyfob, which can be coded for your car by a locksmith or dealer.